This product is high polymer emulsion and powder composed of two-component flexible waterproof mortar, with excellent water resistance, weather resistance, durability; good workability, excellent bond strength and superior water resistance; along with the ability of the flexible crack, tiny cracks in the structural layer to achieve the same waterproof and can be used in place of the kitchen, bathroom and water requirements. This product is used in all water-based materials with good environmental protection, is an energy-saving environmental protection, health and practical new waterproof materials. 


 Scope of application 
 Cement concrete structure, mortar and masonry buildings. Kitchen, bathroom, shower, toilet, terrace, balcony, laundry, pool, swimming pools, flower beds, fish ponds. Especially suitable for the phenomenon is more common high-level subsidence and vibration of the floor. 
 The performance and benefits 
 Long-lasting waterproof, good flexibility, anti-tiny cracks, breathable impervious, waterproof double-sided, non-toxic environmentally friendly available roller or brush, to facilitate construction. 


 Substrate processing 
 A substrate should have a rough no cracks, no grease, sand, loose fixtures, clean flat solid surface structure. 
 2 yin and yang, corner wipe into an arc or obtuse angle to prevent cracks. 
 Brushing waterproof mortar should be preceded by the water fully wetting the substrate, but should not be left out of water flowing on the surface. 
 Mixing requirements 
 Open plastic bucket all inner packing materials removed from the barrel in the first emulsion (B component) into the plastic bucket, and then the powder (group A) slowly into the emulsion of the corresponding Edge down the side with an electric mixer to low speed mixing until slurry evenly without caking. Mixing shall not add water or mixed with a stirring last residue and other impurities. The stirred slurry aside for about 3 minutes, then stir about 30 seconds. Tuned slurry Please be exhausted within 45 minutes. Please water the residual water slurry cleaning construction tools. Waterproofing slurry curing can only be cleared by mechanical means. 


 Construction steps 
 By brush or roller brushing. Brushing to be horizontal, vertical cross to achieve uniform formation of a uniform thickness. Make sure that the first coating layer to the base surface is completely void. 
 (Ie, non-stick hand, room temperature, about 2 to 4 hours) 2. The first layer of the coating is dry, a second layer of brushing, and so on. 
 Any special requirements for the structure, increase the thickness of the third layer construction. 
 (4) Construction of the temperature should be +5 ℃ ~ +35 ℃ 


 Detail treatment 
 A first pipe root brushing with the ground at the junction of pre-mixing a good waterproofing slurry, after laying non-woven reinforcement, and then a second layer of brushing, dry solid third after brushing. 
 Corner, the wall at the junction, the corner is prone to leaking parts, the pre-mixing water slurry in cement mortar base surface brushing, covered with a non-woven reinforcement, and then a second layer of brushing, dry solid third after brushing. 




 Use recommended thickness of the amount of 
 Floor, wall moisture-proof 1.0-2.0mm 1.8-2.5kg / m2 
 Free water waterproof 1.5-2.5mm 2.5-4.0kg / m2 
 Pressure water waterproof 2.0-3.0mm 4.0-5.0kg / square meter 


 Closed water test 
 * Construction of waterproof layer to complete 48 hours after (lower temperature or ventilation of the closed water test may be appropriate to delay); 
 * Shuts the water is not less than 24 hours can be carried out by the inspection and no leakage after paving or construction Next. 

 Note 
 (1) of this product without adding water; 
 2 Do not use this product and other materials, or other brand of product mix; 
 Please be sure to read carefully before using the construction to obtain reliable and satisfactory construction; 
 (4) construction, please stay away from children, avoid contact with the skin; 
 Accidentally touching the eyes, rinse with water immediately or seek medical assistance; 
 (6) is strictly prohibited taking accidentally taking please do not hesitate to seek medical assistance. 

 Packaging Specifications: 5KG, 9KG, 18KG, 30KG 

 Specific reference http://www.ken-de.com