Cody high elasticity of thick acrylic waterproof coating is developed through repeated experimentation and exploration by the company R & D staff from a non-toxic, environmentally friendly high-tech products of the product is a water-based, single component acrylic waterproof coating U.S. imports of pure acrylic emulsion and multi-polyacrylate emulsion as base material, from the preparation to add a variety of additives and inorganic fillers. 

 The main features 
 Strength, high elongation, low temperature resistance, anti-aging. 
 Strong bonding, good extension. 
 · In a variety of wet or dry surface of the base applied directly. 
 · One-component, construction is simple, a short duration. 
 · Non-toxic and tasteless, can be modulated into various color according to user needs. 

 Scope of application 
 Concrete, metal, fiber, tile, masonry, asphalt, polyurethane, SBS base surface, the roof of the building, basements, interior and exterior bathroom Room pools, tunnels, bridges, reservoirs, expansion joints, points grid seam, fell into the mouth, wearing wall pipe. 

 Instructions for use 
 (1) Primary treatment must be smooth, solid, clean, no leakage, uneven at first find out flat. Leaks must first plugging processing, yin and yang should be made of angle of the arc angle. 
 (2) construction method 
 · About the total amount of one-third of the material fell to the surface of the base. 
 Rolling back and forth with a roller surface of the base coating as even as possible, without local deposition and requested multi-Gunshua several, so that without leaving a bubble tight bonding between the coating and the base surface. 
 · Layers of the time interval between the previous layer of paint to dry, non-stick subject (usually takes 2-6 hours, on-site low temperature, humidity, poor ventilation, longer dry time, and vice versa shorter) try to increase large interval of time. 
 · If the water layer thickness is not enough (especially the construction of the facade), the coating layer can be added or several layers of 
 · Outdoor and easy touch stampede parts of the waterproof layer should do the protective layer, protective layer or decorative layer construction to be completed two days later in a waterproof layer. Wipe mortar, in order to facilitate construction in the last time after application of the waterproof layer, immediately sprinkle with clean coarse sand, sanding confined to the facade. 

 The amount of 
 The general construction of the thickness of 1.5-2 mm, 3-4 times of construction, each should be uniform, not more than 1 mm, with about 3-4 kg / m 2. 

 Note 
 Not below 0 ℃ or rain, construction, not in a particularly humid environment without ventilation construction, otherwise the impact of film. 
 Such as the base surface is too dry, should be added to the paint 20-30% water, Stir after roll coating. 
 On each floor coating amount of construction work law, to cut too much or too little. 
 Intermittent or end of the construction as soon as possible with water to clean stained with paint, construction equipment and overalls. 

 Construction tools 
 The base surface clean-up tools: hammer, shovel, wire brushes, brooms, rags, etc.. 
 Paint coated tools: roller, scraper, brush. 

 Store 
 Sealed above 0 ℃, dry stored under direct sunlight conditions, the shelf life of 12 months. 

 Packaging Specifications 
 9kg, 18Kg 
 Specific reference http://www.ken-de.com